The pressure spray dryer is mainly determined by the working principle of the pressure atomizer, which gives this drying system its own characteristics. Since the product obtained by pressure spray drying is particulate, both the mist droplets and the product particles are larger than the other two types, resulting in a longer drying time for the mist droplets. In addition, the atomization angle of the spray is also small, generally around 20 -70 degrees, so the shape of the dryer is mainly a tower shape, so that the mist droplets can have enough residence time. A certain pressure is added to the feed liquid and atomized through the atomizer, so a high-pressure pump is required in the system. In addition, because the atomizer aperture is very small, in order to prevent debris from blocking the atomizer aperture, the material liquid must be filtered before entering the high-pressure pump. Pressure spray drying is mostly used to obtain granular products. Therefore, the final products produced by the pressure spray dryer have their own unique application properties.
Pressure atomizer (called pressure nozzle in some monographs) micro spray dryer is an important component of pressure spray dryer. Pressure atomizer is also called single fluid atomizer or mechanical atomizer in some literature. . The atomization mechanism is that the liquid enters the rotating chamber from the tangential channel of the atomizer at high speed under the pressure of the high-pressure pump, causing the liquid to produce high-speed rotating motion in the rotating chamber. According to the law of conservation of moment of rotational flow, the rotational speed is inversely proportional to the radius of the rotating chamber. Therefore, the closer to the axis, the greater the rotation and the smaller the static pressure. When the rotation speed reaches a certain value and the pressure at the center of the atomizer is greater than the atmospheric pressure, the sprayed liquid forms a cone-shaped annular liquid film rotating around the air center. As the liquid film lengthens, the waves formed by the violent disturbance of the air continue to develop, and the liquid film splits into thin lines. And affected by the radial component velocity of the turbulent flow and the relative velocity of the surrounding air, it finally causes the liquid film to break into filaments. After the liquid filaments are broken, they are affected by surface tension, and finally form a mist group composed of countless mist droplets, and the water evaporates to form particulate products.
Micro spray dryers can be divided into different components according to different systems: hot air circulation system, liquid atomization system, cyclone collection system
Analyze the structural composition of pressure micro spray dryer
May 26, 2023
You May Also Like
Send Inquiry
