Colloid Mill Machine

● Connect the feeder or the feeding tube and the outlet or the discharging circulates tube. And then connect the cold water tube and drain pipe.
● Install the power starter and equipped with Ammeter and indicator light. When the power is on, start the machine and distinguish the direction of motor. From the feeding mouth, the direction should be in clockwise direction.
● Adjust the clearance between the grinding blades and loose the handle. Rotate the adjustment ring in the clockwise direction. Stretching a hand at the bottom of the base and rotate the fan. When the adjustment ring feels a little bit friction, stop the movement. Then rotate in the other direction and make the gap larger than the corresponding figure. As long as the fine degree of particle size of materials is satisfied, the gap should be a litter larger which can increase the service life of blades. Tighten the handle and the adjustment ring in the clockwise direction to fix the gap between them.
● Disinfect the machine completely and clean the inside of the machine.
● Switch on the cooling water and start the colloid mill machine. Feed the materials after the machine's normal operation. The time for idle running is less than 15 seconds.
● There is no quartz, broken glass and metal scrapes mixing into the materials, or the grinding plate of rotor and stator are damaged.
● Be careful the workload of motor. Reduce the feeding amount when the motor works overload.
● Colloid mill machine is high precision machinery and grinding gap is very small, high running speed. The operator should work according to the rules of operation. When the machines are find fault, stop the machine instantly. Start the machine after troubleshooting.
● After using the colloid mill machine, the machine should be cleaned completely without remained materials, to avoid of the leakage of the sealed machinery by adhesion.