Home > Knowledge > Content

Different motion states of the grinding balls during grinding in the laboratory drum ball mill

Feb 06, 2017

The laboratory drum ball mill has a simple structure, wide application and easy operation, and is very popular among laboratory ball mills. The laboratory drum ball mill uses a drum ball mill tank. Grinding balls of different sizes are loaded into the tank. The loading amount is 1/4-1/2 of the effective capacity of the ball mill tank.

When grinding with a laboratory drum ball mill, when the grinding ball filling rate is within a reasonable range and the drum ball mill operates at different speeds, the grinding balls may appear in three basic motion states in the tank. In the first "turnover state", the rotation speed is too high, and the grinding balls are affected by centrifugal force and rotate together close to the wall of the ball mill tank. All the grinding balls form a ring on the inner wall of the tank, and the grinding balls cannot collide and squeeze the material; The second "falling state", the rotation speed is too low, the grinding ball and the material rotate to 30°-50° with the tank wall and then slide down. Although there is partial grinding effect on the material, there is no impact and collision, and the grinding energy is small, resulting in poor grinding efficiency. ; The third "dropping state", at a suitable ball mill speed, under the combined action of centrifugal force and friction, the grinding ball moves with the tank wall to a certain height, then leaves the tank wall and falls freely along a parabolic trajectory. The falling grinding balls impact and grind the materials to crush them.

Send Inquiry
Categories