The following is the basic usage method of petroleum product distillation tester for reference:
Sample preparation: Measure the petroleum sample to be tested with a measuring bottle and put it into the sample bottle of the tester.
Tester preparation: Put an appropriate amount of water or other cooling medium into the heating chamber of the tester, put the sample bottle into the tester, close the lid of the tester, and plug in the power supply.
Set test parameters: According to the standards to be tested and the nature of the sample, set the test parameters on the control panel of the tester, including starting temperature, heating rate, end temperature, etc.
Start testing: Press the start button of the tester to start testing. During the test, the tester will automatically heat the sample bottle, record and display the temperature changes in the sample bottle and the evaporation of the sample.
End of test: When the petroleum sample in the sample bottle completely evaporates or reaches the termination temperature, the tester will automatically stop heating and display the test results.
Data processing: Record the test results, including initial distillation point, final distillation point, fraction yield and other indicators, and perform data processing and analysis as needed.
Cleaning and maintenance: After the test, clean all parts of the tester in time to keep the equipment clean and in good working condition to ensure the accuracy and reliability of the next test.
It should be noted that the specific usage methods and steps may vary depending on different models and brands of petroleum product distillation testers. Please be sure to read the equipment instructions and operation manual carefully before use, and operate in accordance with relevant requirements.
