Working principle of spray dryer
The air is filtered and heated and enters the air distributor at the top of the spray dryer. The hot air enters the drying chamber in a spiral shape evenly. The liquid material passes through the high-speed centrifugal atomizer at the top of the tower and is (rotated) sprayed into extremely fine mist-like droplets, which can be dried into finished products in a very short time when contacted with hot air in parallel flow. The finished product is continuously output from the bottom of the drying tower and the cyclone separator to the centrifugal spray dryer, and the waste gas is exhausted by the induced draft fan.
The spray dryer is a type of continuous atmospheric dryer. Use special equipment to spray the liquid material into mist, and make it dry by contact with hot air. Used for drying some heat-sensitive liquids, suspensions and viscous liquids, such as milk, eggs, tannins and drugs. Spray dryers are also used to dry fuels, intermediates, soap powder and inorganic salts, etc.
Spray dryer product features
1. The spray dryer tower body has a cold air jacket;
2. The spray dryer tower is equipped with an automatic rapping device;
3. The spray dryer tower body and pipelines are equipped with quick-open cleaning holes and drain holes;
4. Automatically control the constant temperature feeding tank;
5. Random accessories for manual high-pressure washing tower;
6. The parts in contact with the material are made of stainless steel;
7. Material collection adopts two-stage cyclone dust collector, or one-stage cyclone dust collector and wet dust collector;
8. The inlet air temperature realizes automatic control and continuous device;
9. Equipped with air sweep device.
In the daily production process, necessary preparations should be made before starting the spray dryer. First, check whether the connections between the bearings and sealing parts of each device of the spray dryer are loose, the lubricating oil condition of each mechanical component, and whether the valve ports of each water, air, and slurry pipe are in the required position. Then turn on the power and check whether the voltage and instruments are normal. Finally, check the amount and concentration of the slurry in the slurry mixing barrel. If any problems occur, they should be eliminated in time.
Then turn on the blower and exhaust fan of the spray dryer in sequence, and then turn on the heating switch to start heating up. When the outlet temperature reaches the set temperature (usually around 130°C), start the material pump and dust removal system. When the pump pressure reaches 2MPa, open the spray gun and start granulation. After the equipment is running, the atomization situation and the working condition of the material pump should be observed in time. If the gun is blocked, the nozzle must be cleaned or replaced immediately.
After the spray dryer equipment is running normally, materials should be collected regularly, the operation of each system should be regularly checked, each process parameter should be recorded, and the vibrating screen should be cleaned.
At the end of granulation, the heating device should be turned off first and the operation of the gas engine should be stopped. Then close the spray gun valve, replace the spray gun, unscrew the nozzle and rinse it clean. When the temperature drops below 100°C, the supply fan and exhaust fan can be stopped. Then clean the remaining materials in the spray drying tower and dust collector, turn off the dust collector and air hammer, and finally turn off the main power supply to complete the production operation.
In case of emergency, the spray dryer equipment must be shut down immediately, and the air supply fan and material pump should be shut down first. If there is a sudden power outage, the gas engine should be pulled out to allow the tower body to cool down naturally, then open the drain valve, drain the slurry in the slurry pipe, and clean the equipment.



