Home > Knowledge > Content

What are the preparations before dissolution test?

Dec 23, 2019

Speaking of dissolution equipment, most people may be familiar with it, but do you know the preparations before testing? Below, I will give you a detailed summary of the preparations before the dissolution test. I hope it will be of significant help to you.
**. It is necessary to check whether the dissolution tester is intact, such as checking the concentricity and whether the water in the water bath is at the warning line. Check the concentricity by using the center cover to check the concentricity of the rotating rod and each dissolution cup. If the test results are not concentric, then the three eccentric wheels next to the cup mouth need to be adjusted until they return to the appropriate position, and then fixed. Secondly, when the water surface of the water bath must reach one to two centimeters of the red line, if it is lower than this level, continue to add water.
Secondly, after connecting the switch of the dissolution apparatus to the AC power outlet, turn on the button on the right side of the instrument. At this time, you should check whether the indicator light is on, whether the water pump is started, whether the water in the water bath starts to circulate automatically, etc. If the water in the water bath is not flowing, there may be air in the hose. blocked. Just let the air out.
Third, number and weigh the samples to be tested, and record the weighing results in detail. At the same time, prepare the dissolution medium and pH value in advance. Generally, the amount of solute in each experiment is between 1000ml and 2500ml. If the prepared solute has foam, it must be left overnight before use, so as to obtain accurate experimental results.
As long as you do the above three points, the dissolution apparatus will run smoothly.

Send Inquiry
Categories