Home > Knowledge > Content

What is the filling degree of the hydrothermal synthesis reactor?

Jul 26, 2024

The hydrothermal synthesis reactor is also called a microreactor or a pressure vessel. Compared with other reactors, it has low cost and simple structure. It uses stainless steel as a pressure-bearing component and is lined with polytetrafluoroethylene. It is more suitable for the reaction of various strong acids, strong alkalis and other media. It has high cleanliness and no corrosion pollution. It can be used for the reaction test of the same component medium under different conditions, and it can also be used for the reaction test of different component media under the same conditions.

What is the filling degree? The filling degree refers to the percentage of the liquid volume to the volume of the hydrothermal decomposition reactor. For example, for a 100ml hydrothermal synthesis reactor, 80ml of solution is poured into the reactor lining, that is, the filling degree is 80%.

The actual filling degree of the hydrothermal synthesis reactor is 60%~80%. If the solubility of the ligand is small, the filling degree can be slightly larger, and the pressure will increase accordingly, but it should not be filled too much, otherwise when the pressure increases to a level that the reactor cannot adapt to, a series of accidents such as reactor damage will occur. Safety is an important factor in operation. Of course, if you want to deliberately adjust the pressure in the reactor, in addition to increasing the filling degree, you can also consider adding some inorganic solvents to the solvent water, or directly reacting a certain proportion of mixed solvents, but pay attention to the operating temperature and do not operate outside the reactor temperature range.

Generally, a filling degree of about 70% is more appropriate. Secondly, consider whether the solubility of the ligand is large or small, and then adjust the filling degree and pressure according to the actual reaction temperature.

How to determine the filling degree of the reactor is generally determined by the solvent system and reaction temperature of the experimental reaction.

1. The mixing coefficient of the reaction materials in the reactor is generally 0.6-0.85;

2. If the material is in a foamy or boiling state during the reaction, it is generally 0.6-0.7;

3. If the material is highly volatile during the reaction, it is generally 0.8-0.85;

The filling degree of the hydrothermal synthesis reactor should also be determined according to the contact structure of the reactor and other operating conditions. It must not only meet the completeness of the reaction, but also ensure that the mixed material is sufficient and does not overflow.

Send Inquiry
Categories