Home > Knowledge > Content

Detailed analysis of the working process of spray dryer

Oct 25, 2023

The contact surface area of the gas and solid phases in the spray dryer is large, but in the spray drying tower, the gas and solid phases flow in a dilute phase, so the volume heat transfer coefficient is small, generally 20~100kcal/m3?h?℃, and the maximum temperature of the hot air is at The temperature is 260~500℃ during parallel flow operation and 200~300℃ during countercurrent operation. The thermal efficiency of industrial-scale spray dryers is generally 30~50%. The thermal efficiency of foreign spray drying with waste heat recovery can reach 70%, but this equipment only makes economic sense when the production capacity is greater than 100kg (water)/h.

Spray dryer is a drying equipment for processing solutions, suspensions or slurry materials. The spray dryer uses a spray method to turn the material into mist droplets dispersed in the hot air. The material and the hot air contact each other in a co-current, counter-current or mixed flow manner, so that the water evaporates quickly to achieve the purpose of drying. Using this drying method, unit operations such as concentration, filtration, and crushing can be omitted, and granular products of 30 to 500 μm can be obtained. The drying time is very short, and the general drying time is 5~30s. It is suitable for drying highly heat-sensitive materials and materials that are easily dispersed during the liquid concentration process. The product has good fluidity and instant dissolution.
The basic process of spray drying is as follows. The material liquid passes through the atomizer and is sprayed into mist droplets dispersed in the hot air flow. The air is sent to the air heater through the blower for heating, and then enters the spray dryer to be dried in contact with the mist droplets. Part of the product falls into the bottom of the tower, and part is sucked into the first-level cyclone separator by the first-level induced draft fan. After separation, the tail gas is vented. The products at the bottom of the tower and the products collected by the cyclone separator are extracted by the secondary exhaust fan, separated by the secondary cyclone separator and then packaged.
The products of spray drying are fine particles. In order to meet the requirements of environmental protection, it is not enough for the spray drying system to only use a cyclone separator to separate the product and purify the exhaust gas. Generally, a bag dust collector is used for purification. Make the dust content in the exhaust gas less than 50 mg/Nm3 gas, or use a wet scrubber to reduce the dust content in the exhaust gas to 15~35 mg/Nm3 gas.

Send Inquiry
Categories