Home > Knowledge > Content

Viscosity Index: What it is and why it matters

Dec 01, 2020

The viscosity of a lubricant is its most important property. Viscosity can be defined as the oil's resistance to flow and shear. It is affected by several factors such as contamination with water, particles or other lubricants. Taking a proactive approach to monitoring lubricant viscosity can have a significant impact on the health and longevity of your machine.

Viscosity is also affected by temperature. The formulation and quality of a lubricant affects how much its viscosity decreases as temperature increases. The change in oil viscosity due to temperature changes is called viscosity index (VI). Understanding the VI is important to discern whether the lubricant in question meets asset requirements based on the operating temperature range.

To determine the VI of an oil, the viscosity is measured at two temperatures: 40 degrees Celsius and 100 degrees Celsius. This is then compared to a scale based on two reference oils. Although VI has no unit of measurement, conventional mineral oils are known to have a viscosity index between 95 and 100. Highly refined mineral oil has a VI of approximately 120. Synthetic oils may have a VI closer to 250. The numbers indicate that the lubricant changes viscosity at a slower rate depending on temperature.

If plotted on a graph with viscosity on the vertical axis and temperature on the horizontal axis, the slope will be more horizontal, the higher the viscosity index. A higher VI is more desirable because it enables the lubricant to provide a more stable lubricating film over a wider temperature range.

Some oils may have the right viscosity at certain temperatures but not fully meet the needs at either end of the temperature range. Keep in mind that small differences in temperature can equate to large changes in viscosity that can be detrimental to the asset.

For example, if the viscosity is too high, it may result in low oil flow, leading to oil starvation and dry starts. When the viscosity is too low, greater mechanical friction may occur, resulting in heavier loads. You will also see more wear due to film loss.

Additives can be used to improve the viscosity index. This allows the lubricant to be formulated to meet OEM specifications. It is always a good idea to check the equipment manufacturer's specifications to determine the appropriate lubricant and consider climate and operating conditions when making your selection. With proper installation and an accurate viscosity index, you can ensure maximum life expectancy and reliable operation of your machine.

Send Inquiry
Categories