Home > Knowledge > Content

What behaviors will cause damage to the glass reactor?

Jul 26, 2024

What behaviors will cause fatal damage to the glass reactor?

The glass reactor can stir and react under normal pressure or negative pressure according to the use requirements in a closed glass reactor under set constant temperature conditions, and can reflux and distill the reaction solution. It is an ideal pilot and production equipment for modern fine chemical plants, biopharmaceuticals and new material synthesis.

Matters needing attention in glass reactor maintenance:

1. Read the instructions carefully before using the glass reactor and check the instrument: check whether the glass reactor body has any signs of damage and whether the interface is consistent.

2. Wipe the interfaces of the glass reactor with a clean soft cloth, apply a little rotating interface on the interface to make the vacuum grease at the interface uniform.

3. The interface of the glass reactor should not be tightened too much. Check the looseness regularly to avoid long-term locking and causing the connector to bite.

4. Turn on the power switch and let the machine run from slow to fast. When stopping, make the machine stop and then turn off the switch.

5. The polytetrafluoroethylene switches at various locations should not be tightened too much to avoid damaging the glass. After stopping, loosen each polytetrafluoroethylene switch. If the machine is stationary in working state for a long time, the polytetrafluoroethylene piston will be deformed.

6. Take the sealing ring of the glass reactor under the glass, check whether there is dirt on the shaft, wipe it with a soft cloth, then apply a little vacuum grease, and reinstall it to keep the shaft and the sealing ring smooth. Clean the sealing ring regularly

7. The electrical part must not be exposed to water and moisture.

8. When replacing parts of the glass reactor, the original accessories produced by the original factory must be used. Using other accessories at will will cause fatal damage to the machine.

9. When making any repairs or inspections, the glass reactor must first cut off the power supply and water source.

10. After the glass reactor is used, the oil stains, stains, and solvent residues left on the surface of the machine must be wiped clean with a soft cloth to keep it clean.

Send Inquiry
Categories