It is very important to clean the heating pipeline of the autoclave to avoid pipeline blockage and reduce the growth of bacteria and viruses. In general, the steps for cleaning heating pipes are as follows:
Turn off the sterilizer and wait for it to cool down.
Open the drain port of the sterilizer and drain the water from the water tank.
Remove the heating lines and clean them. First rinse with clean water, then clean thoroughly with detergent. The cleaning agent can be a special cleaning agent recommended by the manufacturer, or you can use cleaning agents such as deionized water and alcohol. For more stubborn dirt, high-pressure steam cleaning can be used.
Rinse the pipes again with clean water to make sure they are clean.
Check the pipes for cracks or damage and replace them if necessary.
Install the cleaned piping and perform a seal test.
Special attention needs to be paid to safety when cleaning the heating pipeline, because there may still be high-temperature and high-pressure steam remaining in the sterilizer, and it must be waited for to completely cool down before cleaning. At the same time, pay attention to using the correct cleaning agents and methods to avoid damage to the sterilizer.

